10 Easy Steps to Cleaning Salt Cell and Keep Your Pool Sparkling

Looking for a simple and effective way to keep your pool looking its best? Look no further than your salt cell! Whether you’re dealing with cloudy water, algae growth, or just general wear and tear, cleaning salt cell can go a long way in keeping your pool sparkling clean. In this post, we’ll walk you through 10 easy steps to get the job done quickly and easily – so let’s dive in!

What is Cleaning salt cell?

Cleaning Salt cell are the small, round devices that regulate the salt concentration in a pool. They are made of galvanized steel and have a ceramic cup that holds salt. When the cell gets dirty, the water circulates through the cup and cleans it. Dirty cells cause poor water circulation and can lead to algae blooms.

How do salt cells work?

Salt cells are a crucial part of any swimming pool and play an important role in keeping it clean. Salt cells work by absorbing water and turning it into sodium chloride (commonly known as salt). Over time, build-up of organic matter, leaves, and other debris can cause the cells to stop working as efficiently. To keep your pool sparkling clean, follow these easy steps:

1. Sweep or vacuum the pool surface regularly. This will remove any accumulated debris that may have clogged up the salt cells.
2. Rinse off all surfaces of the pool with fresh water after each use. This will help remove any residual dirt, leaves, or chemicals that may have been used in previous swimming sessions.
3. Check the salt level weekly and add new salt wherever needed to maintain a desired chlorine level. Too much salt can lead to brownish water and poor swimming conditions for both children and adults alike.

How to clean a salt cell

Salt cells are essential to the proper function of a pool and should be cleaned on a regular basis. Follow these easy steps to keep your pool sparkling clean:

1. Remove any debris or leaves that may have accumulated on the salt cell over the past week or so. Scrub off any dirt, dust, or residue with a brush.

2. Pour 1 gallon of Pool Shock into the cell and turn it to high speed for 3 minutes. Allow the water to drain out of the cell before turning it off.

3. Use a hose to spray the inside of the cell with chlorine. Turn on the cold water spigot and let it run for 5 minutes before turning off the water supply completely. Allow the chlorine to do its job before moving on to step 4.

4. Rinse out all of the interior surfaces of the salt cell with clean water using a garden hose turned onto full stream. Be sure to get under all of the crevices and around all of the edges where debris can accumulate.

5. Empty and refill your pool with fresh water following step 2 above, then turn on your pump(s). The salt cell will now be working as an impurity filter, helping keep your pool sparkling clean!

How to prevent salt cells from clogging up

To prevent salt cells from clogging up, it’s important to clean them regularly. Salt cell cleaning can be done manually or with a pool vacuum. To clean the cells manually, first rinse them with fresh water and then use a chlorine solution to clean them. To clean the cells with a pool vacuum, run the vacuum cleaner over the entire cell surface. Read more…


Cleaning salt cell is a crucial part of keeping your pool sparkling. By following these easy steps, you can ensure that your pool stays clean and looking great all season long!

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button